DescriptionCommand
• For sensors 1, 3, and 4 (outlet and onboard
sensors), the following actions occur:
• System messages displayed
• SNMP notifications (if configured)
sent
• Log environmental alarm event
triggered (can be reviewed by running
the show alarm command).
• For sensor 2 (intake sensor), the following
actions occur:
• If the threshold is exceeded in a
switching card, only that card is shut
down.
• If the threshold is exceeded in an
active route processor card with
HA-standby or standby present, only
that route processor card is shut down
and the standby route processor card
takes over.
• If you do not have a standby route
processor card in your router, you have
up to 2 minutes to decrease the
temperature. During this interval, the
software monitors the temperature
every 5 seconds and continuously
sends system messages as configured.
We recommend that you install dual route
processor cards. If you are using a router
without dual route processor cards, we
recommend that you immediately replace
the fan card even if just one fan is not
working.
Note
Powers up or shuts down a card.hw-module location <loc> shutdown or [no]
hw-module shutdown location <loc>
Displays the power usage information for the entire
router.
show environment power
Displays the voltage for the entire router.show environment voltage
Displays the current environment status.show environment current
Displays the status of the fan trays.show environment fan
Hardware Installation Guide for Cisco NCS 5700 Series Fixed-Port Routers
100
Verify Chassis Installation
Verify Device Installation
To Next Page
Loading...
Need help?
General
