CHAPTER
2-1
Cisco Nexus 5600 Series Hardware Installation Guide
2
Installing the Cisco Nexus 5600 Series Switches
This chapter describes how to install the Cisco Nexus 5600 switch. This chapter includes the following
sections:
• Preparing for Installation, page 2-2
• Installation Options with Racks and Cabinets, page 2-2
• Airflow Direction, page 2-2
• Chassis Weight, page 2-2
• Installation Guidelines, page 2-3
• Required Equipment, page 2-4
• Unpacking and Inspecting the Switch, page 2-4
• Installing a Cisco Nexus 5600 Series Switch, page 2-5
• Grounding the Switch, page 2-8
• Starting the Switch, page 2-13
Note Before you install, operate, or service the system, see the Regulatory, Compliance, and Safety
Information for the Cisco Nexus 6000 Series, Cisco Nexus 5000 Series, Cisco Nexus 3000 Series, and
Cisco Nexus 2000 Series for important safety information.
Warning
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
To Next Page
Loading...
