4-7
Cisco Nexus 5600 Series Hardware Installation Guide
Chapter 4 Replacing Components
Removing the Cisco Nexus 5600 Platform Chassis
Note If you purchased this product through a Cisco reseller, contact the reseller directly for technical support.
If you purchased this product directly from Cisco, contact Cisco Technical Support at this URL:
http://www.cisco.com/c/en/us/support/web/tsd-cisco-worldwide-contacts.html.
Removing the Cisco Nexus 5600 Platform Chassis
Caution The slider rail and front rack-mount brackets do not have a stop mechanism when sliding in and out. If
the front of the chassis is unfastened from the rack and the chassis slides forward on the slider rails, it
might slip off the end of the rails and fall out of the rack.
To remove the Cisco Nexus 5600 Platform chassis from a rack, follow these steps:
Step 1 Ensure that the weight of the switch is fully supported and that the switch is being held by another
person.
Step 2 Disconnect the power cord and the console cables.
Step 3 Disconnect all cables that are connected to transceivers.
Step 4 Remove the screws fastening the front rack-mount brackets to the mounting rails.
Step 5 Gently slide the switch towards you, off of the slider rails and out of the rack.
Repacking Cisco Nexus 5600 Platform Switch Components or
Cisco Nexus Platform Switch Components for Return Shipment
If you need to return the switch, remove the switch from the rack by following the steps in the
“Removing the Cisco Nexus 5600 Platform Chassis” section on page 4-7, and repack it for shipment. If
possible, use the original packing materials and container to repack the switch. Contact your Cisco
customer service representative to arrange for return shipment to Cisco.
To Next Page
Loading...
