C-2
Cisco Nexus 5600 Series Hardware Installation Guide
Appendix C Cable and Port Specifications
Console Port
Console Port
The console port is an asynchronous RS-232 serial port with an RJ-45 connector.
Supported Power Cords and Plugs
Each power supply has a separate power cord. Standard power cords or jumper power cords are available
for connection to a power distribution unit that has IEC 60320 C19 outlet receptacles. The standard
power cords have an IEC C13 connector on the end that plugs into the switch. The optional jumper power
cords, for use in cabinets, have an IEC C13 connector on the end that plugs into the switch and an IEC
C14 connector on the end that plugs into an IEC C13 outlet receptacle.
Note Only the regular power cords or jumper power cords provided with the switch are supported.
Note If you do not order the optional power cord with the system, you are responsible for selecting the
appropriate power cord for the product. Using a non-compatible power cord with this product may result
in electrical safety hazard. Orders delivered to Argentina, Brazil, and Japan must have the appropriate
power cord ordered with the system.
Table C-2 lists the power cords for the Cisco Nexus 5600 switch and provides their lengths in feet and
meters. Table C-3 lists the power cables for the HVAC/HVDC power supplies (NXA-PHV-1100W and
NXA-PHV-1100W-B).
Table C-2 Power Cords for the Cisco Nexus 5600 Switch
Description
Length
Power Cord Reference
IllustrationFeet Meters
CAB-250V-10A-AR
Power cord 250 VAC 10 A, IRAM 2073 plug
Argentina
8.2 2.5 Figure C-1
CAB-9K10A-AU
Power cord 250 VAC 10 A, 3112 plug,
Australia
8.2 2.5 Figure C-2
CAB-250V-10A-CN
Power cord 250 VAC 10 A, GB 2009 plug
China
8.2 2.5 Figure C-3
CAB-9K10A-EU
Power cord, 250 VAC 10 A, M 2511 plug
Europe
8.2 2.5 Figure C-4
CAB-250V-10A-ID
Power cord 250 VAC 16A, EL-208 plug
South Africa, United Arab Emirates, India
8.2 2.5 Figure C-5
CAB-250V-10A-IS
Power cord 250 VAC 10 A, SI-32 plug
Israel
8.2 2.5 Figure C-6
To Next Page
Loading...
