Cisco Nexus 5600 Series - Jumper Power Cord

C-8
Cisco Nexus 5600 Series Hardware Installation Guide
Appendix C Cable and Port Specifications
Jumper Power Cord
Figure C-14 CAB-IND-10A
Jumper Power Cord
Figure C-15 shows the plug connector on the optional jumper power cord for the Cisco Nexus 5600
Series switches. This cable plugs into the power supply, and the receptacle of a power distribution unit
for a cabinet. This cable comes in 6- and 9-foot (2- and 3-meter) lengths.
Figure C-15 CAB-C13-C14-JMPR, Jumper Power Cord
Table C-3 Power Cable Specifications for HVAC/HVDC Power Supplies
Power Type Power Cord Description
HVAC CAB-HVAC-SD-0.6M 2-foot (0.6 m) cable with Saf-D-Grid and SD connectors (LS-25
straight)
HVAC CAB-HVAC-C14-2M 6.6-foot (2.0 m) cable with Saf-D-Grid and C14 connector (use
for up to 240 V)
HVAC CAB-HVAC-RT-0.6M 2-foot (0.6 m) cable with Saf-D-Grid and RT connector (LS-25
right angle)
HVDC CAB-HVDC-3T-2M 6.6-foot (2.0 m) cable with Saf-D-Grid and three terminal
connectors
Connector
EL701B (IEC60320/C13)
Cordset rating 10A, 250V
(8.2 feet) (2.5m)
Plug:
EL 208B (IS 6538-1971)
192259
Cordset rating 10A, 250V
(686mm)
Plug:
SS10A
186569
Connector:
HS10S