Switch and Module Weights and Quantities
QuantityWeight per UnitComponent
114.2 lb (6.44 kg)Cisco Nexus 9348GC-FXP Chassis
(N9K-C9348GC-FXP)
3—
0.9 lb (0.4 kg)
0.9 lb (0.4 kg)
Fan Module
– Port-side exhaust (blue)
(NXA-FAN-30CFM-F)
– Port-side intake (burgundy)
(NXA-FAN-30CFM-B)
2 (1 for operations and 1 for
redundancy)
—
2.64 lb (1.2 kg)
2.64 lb (1.2 kg)
2.64 lb (1.2 kg)
2.64 lb (1.2 kg)
Power Supply module
– 350-W AC port-side exhaust
(blue) (NXA-PAC-350W-PE)
– 350-W AC port-side intake
(burgundy) (NXA-PAC-350W-PI)
– 440-W DC port-side exhaust
(blue) (NXA-PDC-440W-PE)
– 440-W DC port-side intake
(burgundy) (NXA-PDC-440W-PI)
Transceiver and Cable Specifications
To determine which transceivers, adapters, and cables are supported by this switch, see https://www.cisco.com/
c/en/us/support/interfaces-modules/transceiver-modules/products-device-support-tables-list.html.
To see the transceiver specifications and installation information, see https://www.cisco.com/c/en/us/support/
interfaces-modules/transceiver-modules/products-device-support-tables-list.html.
Switch Power Input Requirements
The following table lists the typical amount of power consumed by the switch, and it lists the maximum
amount of power that you must provision from the power source as input to the power supply and switch for
peak conditions.
Some power supplies might have UL listed capabilities that are greater than the maximum power requirements
for a switch. To determine the power consumption characteristics for the switch, use the typical and maximum
requirements listed in the following table.
Note
Cisco Nexus 9348GC-FXP ACI Mode Hardware Installation Guide
42
System Specifications
Switch and Module Weights and Quantities
To Next Page
Loading...
