CHAPTER 4
Connecting the Switch to the ACI Fabric
• ACI Fabric Topology, on page 29
• Preparing to Connect to Other Devices, on page 30
• Connecting Leaf Switches to APICs, on page 31
• Connecting Leaf Switches to Spine Switches, on page 33
• Installing a Gigabit Ethernet module (GEM), on page 34
• Virtual Port Channel Migration - Migration of Nodes from a First-Generation Switch to a
Second-Generation Switch, on page 34
• Setting Up an Optional Console Interface, on page 35
• Setting Up an Optional Management Connection, on page 36
• Optic Transceiver Removal Using the Optics Extraction Tool , on page 36
• Maintaining Transceivers and Optical Cables, on page 37
ACI Fabric Topology
The ACI fabric topology includes the following major components:
• Application Centric Infrastructure Controller (APIC) appliance (cluster of APICs)
• Leaf switches (for switch compatibility, please see the data sheets).
• Spine switches (for switch compatibility, please see the data sheets).
For additional information, please see the Cisco APIC Installation, Upgrade, and Downgrade Guide.
To prevent sub-optimal forwarding between endpoints, connect every leaf switch in the fabric to every spine
switch in the same fabric.
Note
As shown in the following figure, each APIC is connected to one or two leaf switches and each leaf switch
should be connected to every spine switch in the same fabric.
Cisco Nexus 93180YC-FX3 ACI-Mode Switch Hardware Installation Guide
29
To Next Page
Loading...
