Cisco Nexus 93180YC-FX3 - Page 37

• After initialization, the switch chassis Status (labeled as STA or STS) LED is green.
Step 7 Verify that the system software has booted and the switch has initialized without error messages.
A setup utility automatically launches the first time that you access the switch and guides you through the basic
configuration. For instructions on how to configure the switch and check module connectivity, see the appropriate Cisco
Nexus 9000 Series configuration guide.
Cisco Nexus 93180YC-FX3 ACI-Mode Switch Hardware Installation Guide
31
Installing the Switch Chassis
Starting the Switch