Before you begin
Ensure that before you handle any switch components, you are wearing a grounded electrostatic discharge
(ESD) strap. To ground the strap, attach it directly to earth ground or to a grounded rack or chassis. There
must be a metal-to-metal connection to earth ground.
Step 1 Remove the fiber-optic cables from the transceiver module before removing the transceiver module.
Step 2 Use the wide side of the optics extraction tool to release the bale latch (see the following image).
Step 3 Use the narrow end of the optics extraction tool to carefully remove the transceiver module (see the following
image).
Step 4 Place the transceiver module in an antistatic bag or other protective environment.
Cisco Nexus 9332C ACI-Mode Switch Hardware Installation Guide
37
Connecting the Switch to the ACI Fabric
Optic Transceiver Removal Using the Optics Extraction Tool
To Next Page
Loading...
