QuantityWeight per UnitComponent
2 (1 for operations and 1 for
redundancy)
—
2.64 lb (1.2 kg)
Power Supply Module
– 1100-W AC port-side exhaust
(blue) (NXA-PAC-1100W-PE2)
– 1100-W AC port-side intake
(burgundy)
(NXA-PAC-1100W-PI2)
– 1100-W DC port-side exhaust
(blue) (NXA-PDC-1100W-PE)
– 1100-W DC port-side intake
(burgundy) (NXA-PDC-1100W-PI)
– 1100-W HVAC/HVDC port-side
exhaust (blue)
(NXA-PHV-1100-PE)
– 1100-W HVAC/HVDC port-side
intake (burgundy)
(NXA-PHV-1100-PI)
Transceiver and Cable Specifications
To determine which transceivers, adapters, and cables are supported by this switch, see https://www.cisco.com/
c/en/us/support/interfaces-modules/transceiver-modules/products-device-support-tables-list.html.
To see the transceiver specifications and installation information, see https://www.cisco.com/c/en/us/support/
interfaces-modules/transceiver-modules/products-device-support-tables-list.html.
Switch Power Input Requirements
The following table lists the typical amount of power that the switch consumes. It also lists the maximum
amount of power that you must provision for the switch and power supply for peak conditions.
Some power supplies have capabilities that are greater than the maximum power requirements for a switch.
To determine the power consumption characteristics for the switch, use the typical and maximum requirements
that are listed in the following table.
Note
Heat Dissipation
Requirement
Maximum Power
Consumption (AC or DC)
Typical Power
Consumption (AC or DC)
Switch
TBDTBD586 WCisco Nexus
93600CD-GX
Cisco Nexus 93600CD-GX ACI-Mode Switch Hardware Installation Guide
44
System Specifications
Transceiver and Cable Specifications
To Next Page
Loading...
