www.cisco.com
Tap ADD PARTICIPANT as outlined to add
the entry to the list of participants to be
called.
When all have been added (two in
this example), tap START to call
them all.
Calling more than one
Calling several to initiate a video conference is an
optional feature. If your system permits conferencing,
you may set up a list of several participants and then
call them all in one go. Ask your system administrator,
if in doubt.
Enter a number or URI, or pick an entry from
the Directory, the list of Favorites, or from the
History.
Tap Add participant again. The maximum
number of participants permitted will depend
on your system conguration. Ask your system
administrator, if in doubt.
Tap END to terminate the entire
conference. To disconnect just
one of the participants, tap the
participant’s name along the
bottom line and then tap END.
Locate the next to
be called.
15
Cisco TelePresence System Prole Series, Codec C Series, Quick Set C20, MX200 User guide
D14582.07 User guide Prole Series, Codec C Series, Quick Set C20, MX200, July 2011.
All contents are copyright © 2010–2011 Cisco Systems, Inc. All rights reserved.
To Next Page
Loading...
Need help?
General
