www.cisco.com
If the Touch controller is used in environments with
considerable amounts of electromagnetic noise present,
you may experience an appearance of false signals—as
if someone tapped the Touch controller when nobody
obviously did so.
To cope with this you may set the EMC Resilience Mode
to On. You must then press and hold for a little while,
rather than just tap, in order to make the system aware
of your tapping. This will avoid the appearance of false
signals.
Administrator settings—EMC Resilience mode
42
Cisco TelePresence System Prole Series, Codec C Series, Quick Set C20, MX200 User guide
D14582.07 User guide Prole Series, Codec C Series, Quick Set C20, MX200, July 2011.
All contents are copyright © 2010–2011 Cisco Systems, Inc. All rights reserved.
To Next Page
Loading...
Need help?
General
