Figure 10: Using the Ramps to Remove the Rack from the Pallet
For an empty rack, carefully roll the Cisco R42612 rack toward the front of the pallet. Lift the rack enough
to slide the pallet out from under the rack. We recommend lifting the Cisco R42612 rack with a fork lift, a
chain hoist, or professional movers. Empty racks are not shipped with ramps.
Designate one person whose only job is to slide the pallet out from under the Cisco R42612 rack.
The rack is too heavy for two or three people to lift; use a forklift, chain hoist, or professional
movers.
Caution
Cisco R42612 Rack and RP-Series Metered Input PDU Installation Guide
25
Unpacking the Rack
Removing the Cisco Cisco R42612 Rack from the Pallet
To Next Page
Loading...
Need help?
General