Procedure
Step 1 Unlock and open the door by pulling the handle bottom out and rotating the handle 90° clockwise.
Step 2 While holding the door steady, lift the captive hinge pins until they unlock. See the following figure.
One person should be able to remove the front door unassisted, but having a second person present
to hold the door while the other slides the pins out can speed up the process.
Tip
Step 3 Hold the door with both hands and pull it away from the hinges; once removed, store the door in an upright
position against a flat surface.
Reversing the Front Door
To reverse the front door on the Cisco R42612 Rack so that it opens in the opposite direction, follow these
steps:
Procedure
Step 1 Remove the door as described in Removing and Installing the Front Door, on page 44.
Step 2 Use a 4 mm hex wrench to remove the top and bottom hinges from the rack. See the following figure, callout
1.
Cisco R42612 Rack and RP-Series Metered Input PDU Installation Guide
45
Replacing Components
Reversing the Front Door
To Next Page
Loading...
Need help?
General