Cisco RV134W Administration Guide

Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide 20
3
In the IPv6 Settings section for both the ATM and PTM (RV134W) transfer modes,
enter the following information:
For IPv6
For 6rd
Static DNS 1 & 2 Enter the IP address of the primary and or secondary
Static DNS in the fields (Hint 1.2.3.4).
Mode IPv6
Address Mode Select Dynamic or Static.
If you select Dynamic, it means that if the RA (Router
Advertisement) message that the device receives, has
an M Flag “0”, the device uses SLAAC (Stateless
Address Auto-configuration) to get the IPv6 address; if
the M Flag is “1”, the device uses DHCPv6 to get the
IPv6 address.
If you select Static, enter the following information:
• IPv6 Address
• IPv6 Prefix Length
• Default IPv6 Gateway
• IPv6 DNS1 & DNS2
Prefix Delegation To assign a network address prefix (from ISP) to LAN,
enable Prefix Delegation.
Mode 6rd
6rd Tunneling Select Auto or Manual. If you choose Manual, enter
the following information:
• IPv6 Prefix
• IPv6 Prefix Length
• Border Relay
• IPv4 Mask Length

Cisco RV134W Specifications

General

Brand	Cisco
Model	RV134W
Category	Wireless Router
Language	English