Cisco RV134W

Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide 30
3
In the PPPoA Settings section, enter the following information:
DSL Modulation Select the DSL modulation from the drop-down list.
The default DSL modulation is Multimode
(recommended).
Username Enter the username.
Password Enter the password.
DNS Server Source Select Get Dynamically from ISP or Use These
DNS Servers to manually configure.
Static DNS 1 & 2 Enter the IP address of the primary and or
secondary Static DNS in the fields (Hint 1.2.3.4).
Connect on Demand
Max Idle Time
Select this option if your ISP charges based on the
amount of time that you are connected. When you
select this option, the Internet connection is on only
when traffic is present. If the connection is idle -
that is, no traffic is flowing - the connection is
closed. If you Connect on Demand, enter the
number of minutes after which the connection
shuts off in the Max Idle Time field.
Keep Alive When you select this option, the Internet
connection is always on. In the Redial Period field,
enter the number of seconds after which the
device attempts to reconnect if it is disconnected.