Networking
Configuring LAN Settings
Cisco RV132W ADSL2+ Wireless-N and RV134W VDSL2 Wireless-AC VPN Router Administration Guide 44
3
When the Internet Connection Type is PPTP:
In the PPTP Setting section, enter the following information:
Auto Get IP (DHCP) Check Enable or Disable to enable or disable the
Auto get IP (DHCP) which is a method of
automatically assigning IP addresses. If disabled,
manually configure the IP address.
PPTP Server Type Select IP Address or FQDN.
PPTP Server IP address of the Point-To-Point Tunneling Protocol
server.
Username The username assigned to you by the ISP.
Password The password assigned to you by the ISP.
DNS Server Source The DNS server address. If you already have DNS
server addresses from your ISP, choose Use these
DNS Servers, and enter the primary and secondary
addresses in the Static DNS 1 and Static DNS 2
fields.
To get DNS server addresses from your ISP,
choose Get Dynamically from ISP.
Connect on Demand Select this option if your ISP charges based on the
amount of time that you are connected. When you
select this option, the Internet connection is on only
when traffic is present. If the connection is idle —
that is, no traffic is flowing - the connection is
closed. If you click Connect on Demand, enter the
number of minutes after which the connection
shuts off in the Max Idle Time field.
Keep Alive When you select this option, the Internet
connection is always on. In the Redial Period field,
enter the number of seconds after which the
device attempts to reconnect, if it is disconnected.
To Next Page
Loading...
Need help?
General
