Cisco SPA 525G2

Cisco SPA IP Phone Field Reference
System Tab
Cisco Small Business SPA 300 Series, SPA 500 Series, and WIP310 IP Phone Administration Guide 214
B
PPPoE Settings (Cisco SPA 525G/525G2 Only)
Static IP If static IP was chosen as the type of internet
connection, displays the static IP address assigned to
the phone.
Netmask If static IP was chosen as the type
Gateway Default router IP address. Blank if DHCP assigned.
LAN MTU LAN Maximum Transmission Unit size. Default value:
1500.
Ethernet MTU (Cisco SPA
525G//525G2 SPCP only)
Ethernet Maximum Transmission Unit size. Default
value: 1500.
Duplex Mode Duplex Mode—Choose one of the following to
configure the speed/duplex for the phone’s Ethernet
ports:
• Auto
• 10MBps/Duplex
• 10MBps/Half
• 100Mbps/Duplex
• 100MBps/Half
Parameter Description
Parameter Description
PPPoE Login Name Specifies the account name assigned by the ISP for
connecting on a Point-to-Point Protocol over Ethernet
(PPPoE) link.
PPPoE Login Password Specifies the password assigned by the ISP for
connecting on a Point-to-Point Protocol over Ethernet
(PPPoE) link.
PPPoE Service Name Specifies the service name assigned by the ISP for
connecting on a Point-to-Point Protocol over Ethernet
(PPPoE) link.