EasyManua.ls Logo

Cisco TelePresence SX20 - Rear Panel

Cisco TelePresence SX20
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
D14908.10 SX20 Administrator Guide TC7.3, JULY 2015. www.cisco.com — Copyright © 2012-2015 Cisco Systems, Inc. All rights reserved.
131
Cisco TelePresence SX20 Quick Set Administrator Guide
Microphone 1 (3.5 mm mini-jack)
2 × USB (for future use)
Camera input (custom)
PC video input (DVI-I input)
Main monitor (HDMI 1 output)
Second monitor (HDMI 2 output)
Power Kensington lock
*VISCA™ is a trademark of Sony Corporation
Microphone 2 (3.5 mm mini-jack)
Loudspeaker (3.5 mm mini-jack)
PC audio input (3.5 mm mini-jack)
Network (RJ45)
Power socket
Always use the provided Lite-On PA-1600-2A-LF power
supply.
Output from the power adapter to the codec: 5 A, 12 V
Input to the power adapter: 2 A, 100-240 V, 50-60 Hz
Loudspeaker (line-out)
3.5 mm mini-jack, 3-conductor connector. To be used with
active speakers (built-in amplifier) only.
PC audio input (line-in)
3.5 mm mini-jack, 3-conductor connector. Used when
connecting to a PC or other external playback devices, such
as a DVD player.
Microphone 1 and 2
3.5 mm mini-jack, 4-conductor connector.
We recommend using Cisco Table Microphone 20. If
using another microphone, make sure it complies with the
microphone connector specification on the next page.
2 × USB
For future use. Also for serial communication via RS-232
adapter.
Network connector
Ethernet interface, 1 × 10 Mb / 100 Mb / 1 Gb Ethernet LAN
interface (RJ45).
PC video input
DVI-I socket, digital/analog video input for PC presentations.
Monitor outputs (main and second)
HDMI socket, digital video and audio output for the main
monitor; digital video output for the second monitor.
Camera input, combined HDMI and camera control
The custom camera socket consists of an HDMI connector
for digital video input from the camera, and a connector for
camera control and power.
The VISCA™* protocol for camera control (pan, tilt, zoom) is
supported. Pin no. 20 provides 12 V DC / 1.5 A to the main
camera.
Kensington lock
The Kensington lock may be used to prevent the codec from
being moved or to prevent theft.
Rear panel
The connectors used in a basic setup are highlighted in blue.
Contents
Introduction
Web interface
System settings
Setting passwords
AppendicesAppendices

Table of Contents

Other manuals for Cisco TelePresence SX20

Related product manuals