Cisco TelePresence SX20 - Setting the Administrator Settings Menu Password

D14908.10 SX20 Administrator Guide TC7.3, JULY 2015. www.cisco.com — Copyright © 2012-2015 Cisco Systems, Inc. All rights reserved.
24
Cisco TelePresence SX20 Quick Set Administrator Guide
Setting the Administrator Settings
menu password
This password restricts access to the Administrator Settings
menu that is available on-screen when using the remote
control.
When starting up the video conference system for the first
time anyone can access these settings, because the menu
password is not set.
We strongly recommend that you set a menu
password, because the administrator settings may
severely affect the behavior of the system.
Note that the menu password, as from software version
TC7.0, applies only to the on-screen Administrator Settings
menu accessed with a TRC5 remote control; it does not
apply to the Administrator menu on a Touch controller.
You can read more about password protection in the
► Setting passwords chapter.
Changing the menu password
Click Set/Change Administrator
Settings menu password to open
this dialog.
Enter the new password in the text
input field and click Set to set it.
Click Set without entering
a password to leave the
Administrator menu unprotected
(not recommended).
Navigate to: Configuration > System Configuration
Contents
Introduction
Web interface
System settings
Setting passwords
Appendices
Web interface