Cisco TrustSec - Page 141

7-55
Cisco TrustSec Configuration Guide
OL-22192-01
Chapter 7 Cisco TrustSec Command Summary
default (cts dot1x interface configuration submode)
default (cts dot1x interface configuration submode)
To restore any of the cts dot1x configurations to their default values, use the default command in CTS
dot1x interface configuration submode.
default propagate sgt
default sap
default timer reauthentication
Syntax Description
Defaults There is no default for this command.
Command Modes CTS dot1x interface configuration submode (config-if-cts-dot1x)
Supported User Roles Administrator
Command History
Examples The following example re-enables SGT propagation:
router# config t
router(config)# interface gigabit 6/1
router(config-if)# cts dot1x
router(config-if-cts-dot1x)# default propagate sgt
Related Commands
propagate sgt Restores default to enabled for propagate sgt.
sap Restores default to sap modelist gcm-encrypt null.
timer Restores default 86,400 seconds for the dot1x reauthentication period.
Release Modification
12.2(50) SY This command was introduced on the Catalyst 6500 Series Switches.
Command Description
propagate (cts dot1x
submode)
Enables/disables SGT propagation in dot1x mode.
sap (cts dot1x interface
submode)
Configures CTS SAP for dot1x mode.
timer (cts do1x interface
submode)
Configures the CTS timer.