Cisco TrustSec - Page 163

7-77
Cisco TrustSec Configuration Guide
OL-22192-01
Chapter 7 Cisco TrustSec Command Summary
show cts authorization entries
show cts authorization entries
To display TrustSec NDAC authorization entries, use the show cts authorization entries command in
EXEC or privileged EXEC mode.
show cts authorization entries
Syntax Description This command has no arguments or keywords.
Defaults None
Command Modes EXEC (>); Privileged EXEC (#)
Supported User Roles Administrator
Command History
Examples The following example is show command output from a Catalyst 6500 switch:
router# show cts authorization entries
Authorization Entries Info
Peer-name = annapurna
Peer-SGT = 7-1F05D8C1
Entry State = COMPLETE
Entry last refresh = 01:19:37 UTC Sat Dec 8 2007
Session queuesize = 1
Interface: Gi2/3
status: SUCCEEDED
Peer policy last refresh = 01:19:37 UTC Sat Dec 8 2007
SGT policy last refresh = 01:19:37 UTC Sat Dec 8 2007
Peer policy refresh time = 2000
Policy expires in 0:00:28:26 (dd:hr:mm:sec)
Policy refreshes in 0:00:28:26 (dd:hr:mm:sec)
Retry_timer = not running
Cache data applied = NONE
Entry status = SUCCEEDED
Peer-name = Unknown-0000
Peer-SGT = 0-AD23BDF78
Entry State = COMPLETE
Entry last refresh = 01:30:37 UTC Sat Dec 8 2007
session queuesize = 0
Peer policy last refresh = 01:30:37 UTC Sat Dec 8 2007
SGT policy last refresh = 01:30:37 UTC Sat Dec 8 2007
Peer policy refresh time = 0
SGT policy refresh time = 2000
Policy expires in 0:00:29:27 (dd:hr:mm:sec)
Release Modification
12.2(33) SXI This command was introduced on the Catalyst 6500 series switches.