Cisco TrustSec - Page 165

7-79
Cisco TrustSec Configuration Guide
OL-22192-01
Chapter 7 Cisco TrustSec Command Summary
show cts credentials
show cts credentials
To display the TrustSec device ID, use the show cts credentials command in EXEC or privileged EXEC
mode.
show cts credentials
Syntax Description This command has no commands or keywords.
Defaults None
Command Modes EXEC (>); Privileged EXEC (#)
Supported User Roles Administrator
Command History
Examples
Router# show cts credentials
CTS password is defined in keystore, device-id = r4
Related Commands
Release Modification
12.2(33) SXI This command was introduced on the Catalyst 6500 series switches.
Command Description
cts credentials Specifies the TrustSec ID and password.