7-92
Cisco TrustSec Configuration Guide
OL-22192-01
Chapter 7 Cisco TrustSec Command Summary
show cts role-based counters
show cts role-based counters
To display Security Group ACL enforcement statistics, use the show cts role-based counters show
command. Use the clear cts role-based counters command to clear the counters.
show cts role-based counters
show cts role-based counters default [ipv4 | ipv6]
show cts role-based counters from {sgt_num | unknown} [ipv4 | ipv6 |
to {sgt_num | unknown} [ipv4 | ipv6]]
show cts role-based counters to {sgt_num | unknown} [ipv4 | ipv6 | ]
show cts role-based counters [ipv4 | ipv6]
Syntax Description
Command Modes EXEC (>); Privileged EXEC (#)
Supported User Roles Administrator
Command History
Usage Guidelines Use the show cts role-based counters command to display the Security Group ACL (SGACL)
enforcement statistics. Use the clear cts role-based counters to reset all or a range of statistics.
Specify the source SGT with the from keyword and the destination SGT with the to keyword. All
statistics are displayed when both the from and to keywords are omitted.
The default keyword displays the statistics of the default unicast policy.
When neither ipv4 nor ipv6 are specified this command displays only IPv4 counters.
default Default policy counters
from Specifies the source security group
ipv4 Specifies security groups on IP version 4 networks
ipv6 Specifies security groups on IP version 6 networks
to Specifies the destination security group
sgt_num (0–65533) Specifies the Security Group Tag number
unknown Specifies all Source Groups
Release Modification
12.2(50) SY This command was introduced on the Catalyst 6500 Series Switches.
To Next Page
Loading...
