7-94
Cisco TrustSec Configuration Guide
OL-22192-01
Chapter 7 Cisco TrustSec Command Summary
show cts role-based sgt-map
show cts role-based sgt-map
To display the SXP source IP to SGT bindings table (IP–SGT bindings), use the show cts role-based
sgt-map command in EXEC or privileged EXEC mode.
show cts role-based sgt-map {ipv4_dec | ipv4_cidr | ipv6_hex | ipv6_cidr | all [ipv4 | ipv6] |
host {ipv4_decimal | ipv6_dec} | summary [ipv4 | ipv6] |
vrf instance_name {ipv4_dec | ipv4_cidr | ipv6_dec | ipv6_cidr | all {ipv4 | ipv6} | host
{ipv4_decimal | ipv6_dec} |summary {ipv4 | ipv6} }
Syntax Description
Defaults None
Command Modes EXEC (>); Privileged EXEC (#)
Supported User Roles Administrator
Command History
ipv4_dec Specifies an IPv4 address in dot-decimal notation.
For example (208.77.188.166)
ipv4_cidr Specifies an IPv4 address range in Classless Inter-Domain Routing (CIDR)
For example, 35.0.0.0/8, where the /8 signifies that the 8 most significant bits
identify the networks, and the 24 least-significant bits, the hosts.
ipv6_hex Specifies an IP version 6 address in hexadecimal separated by colons.
For example, 2001:db8:85a3::8a2e:370:7334.
ipv6_cidr Specifies a range of IPv6 address in hexadecimal CIDR notation.
host ipv4_decimal |
ipv6_hex
Specifies mappings for a specific IPv4 or IPv6 host. Use dot decimal and hex
colon notation for IPv4 and IPv6 respectively.
all Specifies all mappings to be displayed.
summary ipv4 | ipv6
Summary of IPv4 or IPv6 mappings. Displays both IPv4 and IPv6 if you do
not specify a keyword.
vrf instance_name Specify a VPN Routing/Forwarding instance for mappings.
Release Modification
12.2 (33) SXI3 This command was introduced on the Catalyst 6500 series switches.
12.2 (50) SG7 This command was introduced on the Catalyst 4000 series switches
(without vrf keyword).
12.2 (53) SE2 This command was introduced on the Catalyst 3750(E) and 3560(E) series
switches (without vrf keyword).
12.2 (53) SE2 This command was introduced on the Catalyst 3750(X) series switches
(without vrf keyword).