Cisco UC500 series - Page 143

LAB 8B: UC520 Multi-site Setup
Cisco Unified Communications Technical Training
Page 143 of 171
18. To configure the dialplan, add the below CLI on the ODD POD ONLY
voice translation-rule 81
rule 1 /^81\(…\)$/ /\1/
!
voice translation-profile oddpod
translate called 81
!
dial-peer voice 82000 voip
destination-pattern 82...
session protocol sipv2
dtmf-relay rtp-nte
codec g711ulaw
no vad
session target ipv4:1.1.100.xx
!where xx is the WAN IP address of the EVEN POD
!
dial-peer voice 81000 voip
incoming called-number 81…
session protocol sipv2
dtmf-relay rtp-nte
codec g711ulaw
no vad
translation-profile incoming oddpod