APPENDIX C: PPPoE on the WAN
Cisco Unified Communications Technical Training
Page 152 of 171
8. Select the “More” button for the IP Phones one at a time as below
o For IP phone with x201,
o Select the Paging Group from the pull down
o Select Intercom to IP phone x202 (bip) from the pull-down. Do not check “Intercom
Mute” box.
o Check all C01 to C04 options – these are the PSTN lines (CO lines) on the 4 FXO ports –
then click OK
o For IP Phone with x202
o Select the Paging Group from the pull down
o The Intercom should show to x201 (aip). Check the “Intercom Mute” box.
o Check C01 to C03 which implies this phone has 3 PSTN lines – then click OK
o For the CIPC phone with x203
o Select the Paging Group from the pull down
o Check C01 to C04 to select all 4 PSTN lines – then click OK
To Next Page
Loading...
General