LAB 1: Plug & Play
Cisco Unified Communications Technical Training
Page 7 of 171
a. After launching CIPC, a Preferences Screen will appear (Right click on the CIPC to view
preferences if it does not appear). Now configure specific TFTP server on the network
tab as the UC520 IP address (192.168.10.1).
Verify steps:
1. Ensure that all the phones register to the UC520 and receive an extension. Verify the extensions
as 201, 202 and 203 (CIPC)
2. Place a call between 201 & 202 – answer the call, place on HOLD and check if the Music on
Hold (MOH) works.
3. Place a call between 201 and CIPC (x203). Answer the call and place on hold on the IP
Communicator and note that the music plays to the IP phone. Take the call off hold and place it
on hold on the IP phone. Note that the IP Communicator only hears a hold tone and not the
MoH source.
NOTE: It is NOT necessary to restore the system to factory defaults at the end of
this lab.
To Next Page
Loading...
General