EasyManuals Logo

Cisco UCS S3260 Service Manual

Cisco UCS S3260
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #69 background imageLoading...
Page #69 background image
3-35
Cisco UCS S3260 Storage Server Chassis Installation and Service Guide
Chapter 3 Maintaining the System
Installing or Replacing System Components
Step 3 Connect the terminated end of the cable to the socket on the power supply. The connector is keyed so
that the wires align for correct polarity and ground, as shown in Figure 3-17.
Step 4 Return DC power from your facility’s circuit breaker.
Figure 3-17 1050 W, –48 VDC Power Supply and Cable
Replacing a DC Power Supply
Note You do not have to power off the system to replace up to one power supply because they are redundant
as 3+1.
Step 1 Remove the power supply that you are replacing or a blank panel from an empty bay:
a. Remove the CAB-48DC-40A-8AWG keyed cable connector from the power supply that you are
replacing.
b. Grasp the power supply handle while pinching the release lever toward the handle.
c. Pull the power supply out of the bay.
Step 2 Install a new power supply:
a. Grasp the power supply handle and insert the new power supply into the empty bay.
b. Push the power supply into the bay until the release lever locks.
c. Connect the CAB-48DC-40A-8AWG keyed cable connector to the new power supply.
d. If you powered off the system, press and hold the system Power button for four seconds to return
the system to main power mode.
1 Keyed cable connector
(CAB-48DC-40A-8AWG)
3 PSU status LED
See Rear-Panel LEDs and Buttons, page 3-4 for details.
2 Keyed DC input socket
305145
1 2 3
1050W DC
+
DC
-
DC

Table of Contents

Other manuals for Cisco UCS S3260

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco UCS S3260 and is the answer not in the manual?

Cisco UCS S3260 Specifications

General IconGeneral
Drive BaysUp to 56
Maximum Storage CapacityUp to 600 TB
Power SupplyUp to 4 hot-plug power supplies
Product TypeStorage Server Chassis
Supported DrivesSAS, SATA
ProcessorsUp to two Intel Xeon Scalable processors
MemoryUp to 1.5 TB DDR4 RAM
Power SuppliesRedundant 80+ Platinum power supplies
Total Drive Bays56
ManagementCisco UCS Manager
CompatibilityCisco UCS system
Form Factor4U rack

Related product manuals