Name: Cisco VG310
Brand: Cisco
Rating: 5 (1 reviews)

To Next Page

To Previous Page

• 1 stop bit

• No parity

• No flow control

Step 3 Key in and dial the telephone number of the voice gateway's external modem.

Connecting to a Remote ASCII Terminal

Procedure

Step 1 Connect the remote ASCII terminal and modem.

Step 2 Set the terminal requirements:

• 9600 baud

• 8 data bits

• 1 stop bit

• No parity

• No flow control

Step 3 Key in the telephone number of the voice gateway external modem, or, if you are using a Hayes-compatible

modem, enter ATDT and the number to be dialed.

Removing and Installing a CompactFlash Memory Card

This section describes how to remove and replace a CompactFlash memory card in Cisco VG310 and Cisco

VG320:

• Removing a CompactFlash Memory Card, on page 24

• Replacing a CompactFlash Memory Card, on page 25

Removing a CompactFlash Memory Card

Do not remove a CompactFlash memory card from the chassis while it is being accessed. This can cause data

corruption and erratic operation. The CompactFlash memory card LED blinks to indicate when flash memory

is being accessed. Removing the CompactFlash memory card from the chassis while flash memory is being

accessed can cause data corruption and erratic operation.

Caution

Installing the Cisco VG310 and Cisco VG320 Voice Gateways

Connecting to a Remote ASCII Terminal

Other manuals for Cisco VG310

Questions and Answers:

Need help?

Do you have a question about the Cisco VG310 and is the answer not in the manual?

General