Name: Cisco VG450
Brand: Cisco
Rating: 5 (1 reviews)

To Previous Page

The following message is displayed at the end of the boot-up messages:

Example:

--- System Configuration Dialog ---

Would you like to enter the initial configuration dialog? [yes/no]:

Step 3 Enter no to proceed with manual configuration using the CLI:

Example:

Would you like to enter the initial configuration dialog? [yes/no]: no

Would you like to terminate autoinstall? [yes]

Step 4 Press Return to terminate autoinstall and continue with manual configuration.

Several messages are displayed, ending with a line similar to the following:

Example:

...

Compiled <date

> <time

> by <person

Step 5 Press Return to bring up the Router> prompt:

Example:

...

flashfs[4]: Initialization complete.

Router>

Step 6 Enter privileged EXEC mode:

Example:

Router> enable

Router#

Step 7 Continue with the Troubleshooting section.

If the rommon 1> prompt appears, your system has booted in ROM monitor mode. For information on the

ROM monitor, refer to the router rebooting and ROM monitor information in the Cisco IOS Configuration

Fundamentals Configuration Guide for your Cisco IOS software release.

Note

Installing the Cisco VG450 Voice Gateway

Power-On Procedure

Questions and Answers:

Need help?

Do you have a question about the Cisco VG450 and is the answer not in the manual?

Cisco VG450 Specifications

General