Cisco WAP131 - Chapter 7: Quality of Service; Global Settings; Configuring Qos Settings for Cisco WAP131

7
Cisco WAP131 and WAP351 Administration Guide 125
Quality of Service
This chapter describes how to configure the quality of service (QoS) feature on
the WAP device. It contains these topics:
• Global Settings
• Class Map
• Policy Map
• QoS Association
• QoS Status
Global Settings
Use the Global Settings page to enable or disable the QoS functionality on the
WAP device, and configure the trust mode and other QoS settings if you are using
a Cisco WAP351 device.
Configuring QoS Settings for Cisco WAP131
To configure the QoS mode on your WAP device:
STEP 1 Select Quality of Service > Global Settings.
STEP 2 In the QoS Mode field, enable or disable the QoS functionality globally on the WAP
device.
STEP 3 Click Save. The changes are saved to the Startup Configuration.