Wireless
Scheduler Association
Cisco WAP131 and WAP351 Administration Guide 99
5
Scheduler Association
The scheduler profiles need to be associated with the WLAN interface or a VAP
interface to be effective. By default, there are no scheduler profiles created, and
no profile is associated with any radio or VAP.
Only one scheduler profile can be associated with the WLAN interface or each
VAP. A single profile can be associated with multiple VAPs. If the scheduler profile
associated with a VAP or the WLAN interface is deleted, then the association is
removed.
To associate a scheduler profile with the WLAN interface or a VAP:
STEP 1 Select Wireless > Scheduler Association.
STEP 2 In the Radio area, select the radio interface to which the configuration parameters
will be applied.
STEP 3 For the WLAN interface or a VAP, select the profile from the Profile Name list.
The Interface Operational Status column shows whether the interface is
currently enabled or disabled.
STEP 4 Click Save. The changes are saved to the Startup Configuration.
Bandwidth Utilization
Use the Bandwidth Utilization page to configure how much of the radio bandwidth
can be used before the WAP device stops allowing new client associations. This
feature is enabled by default.
To change bandwidth utilization settings:
STEP 1 Select Wireless > Bandwidth Utilization in the navigation pane.
STEP 2 Click Enable to enable Bandwidth Utilization, or uncheck Enable to disable this
feature.
STEP 3 In the Maximum Utilization Threshold field, enter the percentage of network
bandwidth utilization allowed on the radio before the WAP device stops accepting
new client associations.
To Next Page
Loading...
