Wireless
Scheduler
Cisco WAP131 and WAP351 Administration Guide 98
5
STEP 3 To add a profile, enter a profile name in the Scheduler Profile Configuration text
box and click Add. The profile name can be up to 32 alphanumeric characters.
Configuring Scheduler Rules
You can configure up to 16 rules for a profile. Each rule specifies the start time, end
time and day (or days) of the week that the radio or VAP can be operational. The
rules are periodic in nature and are repeated every week. A valid rule must contain
all of the parameters (days of the week, hour, and minute) for the start time and the
end time. Rules cannot conflict; for example, you can configure one rule to start on
each weekday and another to start on each weekend day, but you cannot
configure one rule to begin daily and another rule to begin on weekends.
To configure a rule for a profile:
STEP 1 Choose the profile from the Select a Profile Name list.
STEP 2 Click Add Rule.
The new rule shows in the rule table.
STEP 3 Check the box next to the Profile Name and click Edit.
STEP 4 From the Day of the Week menu, choose the recurring schedule for the rule. You
can configure the rule to occur daily, each weekday, each weekend day (Saturday
and Sunday), or any single day of the week.
STEP 5 Set the start and end times:
• Start Time—The time when the radio or VAP is operationally enabled. The
time is in HH:MM 24-hour format. The range is <00-23>:<00-59>. The default
is 00:00.
• End Time—The time when the radio or VAP is operationally disabled. The
time is in HH:MM 24-hour format. The range is <00-23>:<00-59>. The default
is 00:00.
STEP 6 Click Save. The changes are saved to the Startup Configuration.
NOTE A scheduler profile must be associated with a radio interface or a VAP interface to
be in effect. See the Scheduler Association page.
NOTE To delete a rule, select the profile from the Profile Name column and click Delete.
To Next Page
Loading...
