Cisco WAP131 - Page 21

Status and Statistics
System Summary
Cisco WAP131 and WAP351 Administration Guide 21
2
• Base MAC Address—The MAC address of the WAP device.
• Host Name—A name assigned to the WAP device.
• Power Source—The system may be powered by a power adapter, or may
be receiving power over Ethernet (PoE) from a Power Sourcing Equipment
(PSE).
• PSE Status (For WAP351 Only)
- Overload—Indicates that an attached Powered Device (PD) requires
power from the WAP device that is exceeding the configured allocation
any time during the connectivity.
- Down—Indicates that there is no PD device connector or there is a
malfunction.
- Up—Indicates that PSE normally works on 802.3af mode.
• PSE Power Consumption (For WAP351 Only)—The power allocation for
the connected PD device.
• Firmware Version (Active Image)—The firmware version number of the
active image.
• Firmware MD5 Checksum (Active Image)—The checksum for the active
image.
• Firmware Version (Non-active)—The firmware version number of the
backup image.
• Firmware MD5 Checksum (Non-active)—The checksum for the backup
image.
• System Uptime—The time that has elapsed since the last reboot.
• System Time—The current system time.
The TCP/UDP Service table shows basic information about protocols and
services operating on the WAP device, including:
• Service—The name of the service, if available.
• Protocol—The underlying transport protocol that the service uses (TCP or
UDP).
• Local IP Address—The IP address, if any, of a remote device that is
connected to this service on the WAP device. All indicates that any IP
address on the device can use this service.