Cisco WAP131 - Page 58

Administration
Packet Capture
Cisco WAP131 and WAP351 Administration Guide 58
3
- Radio 1/Radio 2—802.11 traffic on the radio interface.
- Ethernet—802.3 traffic on the Ethernet port.
- Radio 1 - VAP0/Radio 2 - VAP0—VAP0 traffic.
- Radio 1 - VAP1 to Radio 1 - VAP3 (if configured)—Traffic on the
specified VAP.
- Radio 2 - VAP1 to Radio 2 - VAP3 (if configured)—Traffic on the
specified VAP.
- Radio 1 - WDS0 to Radio 1 - WDS3 (if configured)—Traffic on the
specified WDS.
- Radio 2 - WDS0 to Radio 2 - WDS3 (if configured)—Traffic on the
specified WDS.
- Brtrunk—Linux bridge interface in the WAP device.
• Capture Interface (For WAP351 Only)—Enter a capture interface type for
packet capture:
- Radio 1/Radio 2—802.11 traffic on the radio interface.
- LAN1 to LAN5—802.3 traffic on the Ethernet port.
- Radio 1 - VAP0/Radio 2 - VAP0—VAP0 traffic.
- Radio 1 - VAP1 to Radio 1 - VAP7 (if configured)—Traffic on the
specified VAP.
- Radio 2 - VAP1 to Radio 2 - VAP7 (if configured)—Traffic on the
specified VAP.
- Radio 1 - WDS0 to Radio 1 - WDS3(if configured)—Traffic on the
specified WDS.
- Radio 2 - WDS0 to Radio 2 - WDS3(if configured)—Traffic on the
specified WDS.
- Brtrunk—Linux bridge interface in the WAP device.
• Capture Duration—Enter the time duration in seconds for the capture. The
range is from 10 to 3600. The default is 60.
• Max Capture File Size—Enter the maximum allowed size for the capture file
in kilobytes (KB). The range is from 64 to 4096. The default is 1024.
STEP 4 Click Save. The changes are saved to the Startup Configuration.