Cisco WAP551 - Page 115

Wireless
Scheduler
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point 84
5
Configuring Scheduler Rules
Configuring Scheduler Rules
You can configure up to 16 rules for a profile. Each rule specifies the start time, end time and
day (or days) of the week the radio or VAP can be operational. The rules are periodic in nature
and are repeated every week. A valid rule must contain all of the parameters (days of the week,
hour, and minute) for the start time and the end time. Rules cannot conflict; for example, you
can configure one rule to start on each weekday and another to start on each weekend day, but
you cannot configure one rule to begin daily and another rule to begin on weekends.
To configure a rule for a profile:
STEP 1 Select the profile from the Select a Profile Name list.
STEP 2 Click Add Rule.
The new rule shows in the rule table.
STEP 3 Check the box next to the Profile Name and click Edit.
STEP 4 From the Day of the Week menu, select the recurring schedule for the rule. You can configure
the rule to occur daily, each weekday, each weekend day (Saturday and Sunday), or any single
day of the week.
STEP 5 Set the start and end times:
• Start Time—The time when the radio or VAP is operationally enabled. The time is in
HH:MM 24-hour format. The range is <00-23>:<00-59>. The default is 00:00.
• End Time—The time when the radio or VAP is operationally disabled. The time is in
HH:MM 24-hour format. The range is <00-23>:<00-59>. The default is 00:00.
STEP 6 Click Save. The changes are saved to the Startup Configuration.
NOTE A Scheduler profile must be associated with a radio interface or a VAP interface to be in effect.
See the Scheduler Association page.
NOTE To delete a rule, select the profile from the Profile Name column and click Delete.