Administration
Management Access Control
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point 41
3
STEP 3 Click Save. The changes are saved to the Running Configuration and to the Startup
Configuration.
Management Access Control
You can create an access control list (ACL) that lists up to five IPv4 hosts and five IPv6 hosts
that are authorized to access the WAP device configuration utility. If this feature is disabled,
anyone can access the configuration utility from any network client by supplying the correct
WAP device username and password.
If the management ACL is enabled, access through the web and SNMP is restricted to the
specified IP hosts.
CAUTION Verify any IP address that you enter. If you enter an IP address that does not match your
Administrative computer, you will lose access to the configuration interface. It is highly
recommend to give the Administrative computer a static IP address, so the address does not
change over time.
To create an access list:
To Next Page
Loading...
