Cisco WAP551 - Groups

Simple Network Management Protocol
Groups
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point 134
8
STEP 4 Click Save. The view is added to the SNMPv3 Views list and your changes are saved to the
Startup Configuration.
NOTE To remove a view, select the view in the list and click Delete.
Groups
SNMPv3 groups allow you to combine users into groups of different authorization and access
privileges. Each group is associated with one of three security levels:
• noAuthNoPriv
• authNoPriv
• authPriv
Access to Management Information Bases (MIBs) for each group is controlled by associating
a MIB view to a group for read or write access, separately.
By default, the WAP device has two groups:
• RO—A read-only group using authentication and data encryption. Users in this group
use an MD5 key/password for authentication and a DES key/password for encryption.
Both the MD5 and DES key/passwords must be defined. By default, users of this group
have read access to the default all MIB view.
• RW—A read/write group using authentication and data encryption. Users in this group
use an MD5 key/password for authentication and a DES key/password for encryption.
Both the MD5 and DES key/passwords must be defined. By default, users of this group
have read and write access to the default all MIB view.
NOTE The default groups RO and RW cannot be deleted.
NOTE The WAP device supports a maximum of eight groups.