Administration
System Settings
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point 26
3
System Settings
The System Settings page enables you to configure information that identifies the WAP device
within the network.
To configure system settings:
STEP 1 Select Administration > System Settings in the navigation pane.
System Settings
STEP 2 Enter the parameters:
• Host Name—Administratively assigned name for the WAP device. By convention, the
name is the fully qualified domain name of the node. The default host name is wap
concatenated with the last 6 hex digits of the MAC address of the WAP device. Host
Name labels can contain only letters, digits and hyphens. Host Name labels cannot
begin or end with a hyphen. No other symbols, punctuation characters, or blank spaces
are permitted. The Host Name can be 1 to 63 characters long.
• System Contact—A contact person for the WAP device. The System Contact can be 0
to 255 characters long and can include spaces and special characters.
• System Location—Description of the physical location of the WAP device. The System
Location can be 0 to 255 characters long and can include spaces and special characters.
STEP 3 Click Save. The changes are saved to the Startup Configuration.
User Accounts
One management user is configured on the WAP device by default:
• User Name: cisco
• Password: cisco
To Next Page
Loading...
