Cisco WAP551 - Page 165

Client Quality of Service
Client QoS Association
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point 132
7
551/561
STEP 2 On WAP561 devices only, select the radio interface on which you want to configure the
association (Radio 1 or Radio 2).
STEP 3 From the VAP list, select the VAP on which you want to configure client QoS parameters.
STEP 4 Select Enable for the Client QoS Global to enable this feature.
STEP 5 Configure these parameters for the selected VAP:
• Client QoS Mode—Select Enable to enable client QoS functionality on the selected
VA P.
• Bandwidth Limit Down—The maximum allowed transmission rate from the WAP
device to the client in bits per second (bps). The valid range is from 0 to 300 Mbps.
• Bandwidth Limit Up—The maximum allowed transmission rate from the client to the
WAP device in bits per second (bps). The valid range is from 0 to 300 Mbps.
• ACL Type Down—The type of ACL to apply to traffic in the outbound (WAP device-
to-client) direction, which can be one of these options:
- IPv4—The ACL examines IPv4 packets for matches to ACL rules.
- IPv6—The ACL examines IPv6 packets for matches to ACL rules.
- MAC—The ACL examines Layer 2 frames for matches to ACL rules.
• ACL Name Down—The name of the ACL applied to traffic in the outbound direction.