Client Quality of Service
Client QoS Status
Cisco Small Business WAP551 and WAP561 Wireless-N Access Point 134
7
Client QoS Status
Use these fields to configure Client QoS Status:
• Station—The Station menu contains the MAC address of each client currently
associated with the WAP device. To view the QoS settings applied to a client, select its
MAC address from the list.
• Global QoS Mode—Whether QoS is enabled globally on the WAP device. This status
is configured on the Client QoS Association page.
• Client QoS Mode—Whether QoS is enabled on the associated VAP. This status is
configured on the Client QoS Association page.
• Bandwidth Limit Down—The maximum allowed transmission rate from the WAP
device to the client in bits per second (bps). The valid range is from 0 to 4294967295
bps.
• Bandwidth Limit Up—The maximum allowed transmission rate from the client to the
WAP device in bits per second (bps). The valid range is from 0 to 4294967295 bps.
• ACL Type Up—The type of ACL that is applied to traffic in the inbound (client-to-
WAP) direction, which can be one of these options:
- IPv4: The ACL examines IPv4 packets for matches to ACL rules.
- IPv6: The ACL examines IPv6 packets for matches to ACL rules.
- MAC: The ACL examines Layer 2 frames for matches to ACL rules.
• ACL Name Up—The name of the ACL applied to traffic entering the WAP in the
inbound direction. When a packet or frame is received by the WAP, the ACL rules are
checked for a match. The packet or frame is processed if it is permitted and discarded
if it is denied.
• ACL Type Down—The type of ACL to apply to traffic in the outbound (WAP-to-
client) direction, which can be one of these options:
To Next Page
Loading...
