<Canceling the Time Setting Warning Function>
1. Sufficiently charge the watch to level 2 where the watch can be used without
risk of stopping (refer to the Charge Level Indicator).
2. Set the mode hand to the time mode and pull the crown out to the second
position to set the time. Flashing of the digital display can only be canceled in
the time mode. After correcting the time, return the crown to the normal
position.
3. Set the mode hand to the calendar mode and pull the crown out to the second
click to set the date. Flashing of the digital display is canceled in the calendar
mode.
4. After correcting the date, return the crown to the normal position.
Note:
• The time setting warning function will not be canceled unless the time is first
set followed by setting the date.
• It takes a minimum of 30 minutes until the watch switches to the time setting
warning display after the watch has stopped due to insufficient charging
even if the watch is exposed to light.
(Case of CAL No. C651, C652)
• The watch will stop if its remains insufficiently charged for about 1.5 days.
• When the watch is sufficiently charged by exposing to light after the watch
has stopped as a result of being insufficiently charged, each hand begins to
move from the reference position (12:00:00, UTC or January 1 SU, UTC)
simultaneous to the digital display beginning to keep time.
• Since the time is incorrect, reset the time, date and each of the other modes.
52 53
To Next Page
Loading...
