55
[Overcharging Prevention Function]
When the energy storage cell becomes fully charged by exposing the dial of the
watch (solar cell) to light, the overcharging prevention function is activated. This
lets you expose the watch to light without worrying about overcharging.
54
CAL No. C650
When power is not generated as a result
of the solar cell not being exposed to
light, the second hand stops when it
reaches the zero seconds position and
the watch automatically enters the power
save state to inhibit power consumption
of the secondary battery.
CAL No. C651, C652
The Power Save mode is activated if
power continues not to be generated by
exposing the solar cell to light for 30
minutes or more.
(Analog Display)
• The second hand stops at the base position (12:00).
• Other hands continue to keep the correct time.
(Digital Display)
• In coordination with the analog second hand stopping at the zero seconds
position, the entire digital display goes out. However, the alarm,
chronograph and other functions continue to measure time internally even
though there is no display.
[Power Save 1]
To Next Page
Loading...
