Citizen CL-S6621 - Page 57

57
Appendixes
Indication Check Corrective action
The printing
position
changes.
5) Are the sensitivities
of the media sensors
appropriate for the
media that is used?
5) Set the media sensitivity to
appropriate values.
If this does not solve the
problem, change the “Sensor
level” that is set in the “System
setup.”
The ribbon is
wrinkled
1) Is the ribbon tension
suitable for the ribbon
that is used?
1) Adjust the tension with the
ribbon tension adjustment
knob.
2) Is the ribbon used
correctly balanced to
the right and left?
2) Adjust the left - right balance
with the ribbon balance
adjustment knob.
3) Is the printing density
too high?
3) Set the appropriate printing
density using the menu or
control software.
4) Are the media
and ribbon the
recommended
products or
equivalent products?
4) Use the recommended
products or equivalent
products. If this does not
correct the problem, contact a
service representative.
The ribbon slips
(ribbon dirt is
produced.)
1) Is the ribbon tension
suitable for the ribbon
that is used?
1) Adjust the tension with the
ribbon tension adjustment
knob.
The ribbon
does not wind.
1) Is the ribbon set in
the correct course?
1) Set the ribbon in the correct
course.
2) Is the ribbon winding
direction reversed?
2) Set the correct winding
direction.
Troubleshooting
Ribbon Tension Adjustment
(p.52)
Ribbon Balance Adjustment
(p.53)
Ribbon Tension Adjustment
(p.52)
Setting the Ribbon (p.28)