5.8 Self test and HEX-DUMP mode
1) Press the power button for approximately 3 seconds to turn off the printer.
2) While pressing the feed button, press the power button and hold both until the beep sounds.
3) Printing will commence.
Print sample
ＳＥＬＦ－ＴＥＳＴ
**********************************
Printer is as follows
Firmware Version Ver.1.16c
**********************************
Flash Memory : 2MByte
Board Version : Newer
PRINT DENSITY : [ 0 ]
**********************************
Serial Interface
Baud rate : 115200
Data bits : 8 bits
Parity : none
Stop bits : 1 bit
Handshaking : DTR/DSR
Receive error: ignore
**********************************
Bluetooth mode : spp + iap
LOCAL Name : Mobile Printer
BD_ADDR :00:13:7B:52:D6:F4
**********************************
MSR : Option
Read Mode : Auto TRACK1/2
**********************************
Emulation : ESC/POS
PrintDensity : Normal
Characters : 32 Char/Line
**********************************
Please press FEED button...
Important note:
If the FEED button is pressed within 30 seconds, it will print additional ASCII printing patterns.
Self-test completes automatically after printing ASCII printing patterns.
Self-test completes automatically if the FEED button is not pressed within 30 seconds.
5.9 HEX-DUMP mode
Within 30 seconds after the printing completes, briefly press the FEED button once more to switch to
HEX-DUMP print mode.
If the FEED button is not pressed within 3 seconds, it will switch to standard mode.
In HEX-DUMP print mode, data received will be printed in HEX format.
To exit HEX-DUMP print mode, turn off the power.
To Next Page
Loading...
