EasyManuals Logo

Citizen CMP-20 Technical Manual

Citizen CMP-20
22 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
CMP-30 product specification document
9
2.4 Power supply specifications
1) Power consumption
While printing: Approx. 1.5 A (ASCII printing)
Peak: Approx. 4.0 A (100% printing ratio for under 10 seconds)
Standby: Bluetooth approx. 110 mA (power ON, not printing, not feeding paper)
Wireless LAN approx. 160 mA (power ON, not printing, not feeding paper)
Reference values
Continuous printing length from full charge: 236 m (approx. 76 mm/sec. printing speed)
Continuous printing time from full charge: 52 minutes (approx. 76 mm/sec. printing speed)
Period charge is held from full charge: With power OFF recharge required after approximately 14
days
2) Charger
1)
Input voltage:
AC 100V-240V, 50/60 Hz
2)
Input current:
0.2 A maximum
3)
Rated input power:
11 W
4)
Output rating:
DC 8.4 V
5)
Output current:
0.8 A
6)
Rated output power:
6.72 W
7)
Efficiency:
74.2% or higher
8)
Short circuit protection:
Short circuit cancellation returns the unit to its normal state
without breakage
or damage to parts during an output short
circuit.
9)
Safety standards:
UL, C-UL, KC, C-Tick, CE, SAA, PSE
10)
Size:
74 mm (L) x 46.6 mm (W) x 40 mm (H) not including the plug
11)
Cable:
1.5 m length/UL2464 20AWG
12)
Plug:
φ3.5 outer circumference x φ1.35 inner circumference x 8.0 mm
length
13)
Terminal polarity:
Center positive (+), outer negative (-)
14)
Mass:
Approx. 100 g
15)
Operating temperature, humidity:
-10°C-35°C, 10%-90% humidity
16)
Storage temperature, humidity:
-20°C-80°C, 10%-90% humidity
The battery pack can be recharged by plugging the charger into the printer or the charging cradle.
Charging time: Approx. 150 minutes
The charge LED meanings are as follows:
Charge LED
State
Red continuously lit
Charging
Green continuously lit
Charge complete
Red flashing
Charging error detected
If an error occurs during charging, charging will stop and the charge LED will flash red.
Re-connecting the charger commences charging and the LED will remain continuously lit red.
If you charge the printer itself you cannot tell the charge condition from the printer.

Other manuals for Citizen CMP-20

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Citizen CMP-20 and is the answer not in the manual?

Citizen CMP-20 Specifications

General IconGeneral
BrandCitizen
ModelCMP-20
CategoryPrinter
LanguageEnglish

Related product manuals