36
<How to cancel the dive mode>
(1) Press button (A) for 2 seconds or more after diving or in the water where it
is less than 1 m (5 ft) deep (depth indication: 0 m/0 ft). The dive mode is
canceled and the watch returns to the time mode.
(2) When the watch is left for 10 minutes after diving or in the water where it is
less than 1 m (5 ft) deep (depth indication: 0 m/0 ft), the watch automatically
returns to the time mode with cancellation of the dive mode. If the watch is
again immersed in the water 1 m (5 ft) or more deep within 10 minutes after
the last dive, the new dive is regarded as a continuation of the last dive and
the watch continues to measure depth.
* Wet detection error indication
If the diving standby mode (water sensor is in action) continues for 1 hour or
more, the function hand points at the overzone mark.
If the watch remains in this status for a long time, refer to
“9. TROUBLESHOOTING.”
To Next Page
Loading...
