46
10. SETTING FUNCTION HAND AT “0” POSITION
(1) Set the watch to the time mode or
chronograph mode.
Turn the crown to loosen it and pull it
out to the second click stop position.
(2) Press button (A) or (B) to set the
function hand to the “0” position.
When the function hand is at the right
side of the “0” position, press button
(A).
When the function hand is at the left
side of the “0” position, press button
(B).
(3) Press the crown in to the normal
position and turn it until it is tightly
screwed against the case.
“0” position
Within ±15 graduations before/after
the “0” point.
Adjusting position
(B)
(A)
To Next Page
Loading...
