45
● The function hand continues to indicate the overzone mark.
If the water sensor gets dirty or wet, it is activated even when the watch is not
wet and the wet detection error indication (the function hand points to the
overzone mark) appears.
In case the watch falls into this status, carefully clean the water sensor part and
wipe out moisture completely.
After the water sensor is cancelled, the normal display will be resumed.
* If careful cleaning results in failure in recovering the watch from the above-
mentioned status, it is possible that the pressure sensor is faulty. In that case,
immediately stop using the watch and consult with the store where you
purchased the watch or the nearest Citizen Service Center.
● The watch malfunctions otherwise or shows abnormal reading.
If a strong shock or static electricity is given to the watch, the watch may come
into abnormal running that is out of explanation of this instruction manual.
If the watch falls into such a status, adjust it following the instructions of
“11. ALL RESET/ADJUSTING HAND POSITION”.
To Next Page
Loading...
